ep

January 20, 2021

Energy UNITS FOR LIFT TABLE one
Standard Description
This energy unit is intended exclusively for the smaller lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit is widely employed during the market of logistic units for example minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled through the solenoid valve together with the speed managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Standard Description
This electrical power unit is designed solely for your medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve and also the pace controlled through the adjustable needle valve. Once the lift rises to a large positoin, however the electrical power supply is lower, the decreasing movement is managed from the guide override perform.
Electrical power UNITS FOR LIFT TABLE three
General Description
This energy unit is developed exclusively for that massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and the velocity managed by a stress compensated flow control valve.
Power UNITS FOR LIFT TABLE 4
Standard Description
This energy unit is built exclusively for that significant lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as speed controlled by the adjustable needle valve. When the lift rises to a higher positoin, but the energy provide is minimize, the lowering movement is controlled through the guide override function.
Particular Notes
1. This power unit is of S3 duty cycle, which might only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean the many hydraulic components concerned in advance of installation of the electrical power unit.
three. Viscosity with the oil shoud be 15~46 cst,which must also be clean and no cost of impurities.N46 hydraulic oil is advisable.
four. Oil transforming is required just after the preliminary a hundred operation hrs,afterwards once every 3000 hrs.
5. The power unit proven is designed to be mounted vertically.