ep

January 22, 2021

SMR Gearbox Installation
Satisfactory efficiency relies on proper set up. lubrication and maintenance. for that reason it is crucial the directions inside the installation and upkeep leaflet. provided with every single gearbox. are followed very carefully. some of the essential aspects of belt and torque-arm installation are listed beneath.
one. Install pulley on gearbox input shaft as shut to the reducer doable, and mount reducer on driven shaft as shut to bearing as useful. failure to complete this may result in excess loads from the input shaft bearings and output bearings and could induce their premature failure.
two. Install motor and wedge belt drive with all the belt pull at approximately 90° towards the center line amongst driven and input shafts. this will permit tensioning on the wedge belt drive using the torque arm which should preferably be in stress. if output hub runs anti-clockwise. torque arm need to be positioned the correct.
three. lnstall torque-arm fulcrum on the rigid assistance in order that the torque-arm will probably be at about right angles on the center line through the driven shaft as well as the torque arm case bolt. be sure there’s enough consider up while in the turnbuckle for belt stress adjustment.
Hold shut.
Bell drive might be situated in any practical postion. in case the torque arm will be to be utilized to tighten the belts, the drive ought to be at about tight angle on the line involving the input and output shafts.
Bell drive could be positioned to your right if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite path to that shown inside the illustration.
Torque arm and belt consider up.
Torque arm may be mounted towards the proper if wanted.